Saturday, 8 December 2012

Scarecrow Mask Halloween Costume

This is a Halloween costume I made for my friend and thought I’d share the making process.

To start I used a swimming hat along with Vaseline to cover any hair on the as any exposed hair would stick to plaster and be very difficult to get off. I then with a bowl of warm water dipped the plaster bandage into it being careful to rub any excess off. I applied this to the face in an even coating and left to harden on the face for approximately 20 minutes. I removed the plaster bandage mask and left it to dry in a warm area for 24hours. 


Once the mask was fully dry (if it is still damp to the touch leave to dry longer) I cut-out the general shape of where the eyes and mouth would be. As I used plastic piping connectors for the vent at either side, using glue and more plaster bandage to set into place. I then painted round the exposed areas of the mask namely the eyes, vents and I used a black piece of cloth to cover the mouth area.


There were many different sackcloth materials which I looked at to cover the mask but I found that many sackcloth were woven sparsely, typically these were sackcloth that would be used for covering bushes from harsh weather in winter. I needed a very tight weave so that the underline shell of the mask could not be seen. I found rice sackcloth bags to be the best for this, I used sack string to sew in the stitches across parts of the face and this also helped to conceal the parts that had to be sewn together.


I then built up the area of the mask such as bumps and irregularities with more plaster bandage and again left to dry for 24hours. Finally sticking down the sackcloth material to the cased plaster, to blend the mask and make it look old and worn I used a combination of acrylic paints diluted in tea and tea bags to stain the sackcloth this took approximately three days to dry as the sackcloth had a waxy coating on it and the stand was slow to take to it. The hole project cost in the region $20 and took about a week to make, allowing for drying time.



Saturday, 17 November 2012

Bumblebee Transformer Halloween Costume





This is my 2011 Bumblebee Transformer Halloween costume.
I used mainly cardboard with duck tape, masking tape, hot glue gun and yogurt pots to create the main car body shape. Once the parts were all attached I used cable ties to secure the hinge on the transformer, this seemed to work quite well and kept the car from tearing apart after a few transforms. Finally I added working spot lights, foam, straps to the inside of the car and gave it two white primer undercoats before yellow spray paint. It took approximately 60 hours to make and cost in the region $60-70

 

Saturday, 12 November 2011

SAW Reverse Bear Trap

SAW Reverse Bear Trap


Halloween mask, from the Saw movies – The Reverse Bear Trap

The main frame was made from cardboard and lollypop sticks, add a working alarm clock, battery charger and working lock to the back. The rest of the mask was built up using bike cogs and parts such as breaks, gear leavers, tubes and springs. Once the main parts were in place I used plaster bandage to firm and hold all the elements in place. Finally added foam to the inside trims for comfort as it is very heavy, painted and dry brushed. 



Welcome

Helloand welcome, I started this blog to post my latest creative works. 
I’m hugely into all types of game art and have various interests in other art media such as 3D/2D animation, Film making, SFX, Model-making and sculpting.
Thank you for viewing, I hope you enjoy